The cold water pressure in my tub is very low. It basically just trickles out, but the hot water is fine.
Anyone know why or have any ideas on how to fix it?
The cold water pressure in the rest of the house is great.

I usually wash my towels, socks, and white undershirts under hot-warm. However, I have this one white t-shirt with a graphic on it that says to wash cold, does it really matter if I throw it in with the hot wash cause it’s the only white material I have that calls for a cold wash.

Im on a well pump and its -3 degres outside right now. I went to turn on the water and I only get really cold water and extremely low pressure. Could it be that the water is frozen or the pump? If that could be the case what can I do to get hot water to the house again?
I should have mentioned we have a tankless water heater and the pilot light is lit. The water pressure we do have just drips.

what could be wrong? Normally our hot water may run cold if some one is running the hot water out by washing clothes, taking showers or baths or from the dishes..now the water just gets cold for no reason..what could be the problem?

The theremostat broke off my shower months ago and until I can get it fixed, the temperature is fixed at a fairly hot setting. After about 10 minutes a loud bang is emitted (I think from the pipes) which is then heard outside where the vent is. I know I need to get the thermostat fixed but does anyone know why this is happening? Is it becuase of the surge of hot water needed to run the shower? Is it causing damager? It only happens when running a hot shower.

Using the littlest bit of cold water drops water pressure and I lose hot water in my shower and probably other places. Why does the pressure drop and why does it affect the hot water?
Please Help!

Angora is the keratin-rich undercoact of many hairy mammals. Explain why, whne you wash an angora sweater in hot water or run it through the hot cycle of a dryer, it will shrink—- permanently!

any help with this would be useful. nothing to broad, but nothing to obvious either.

I have a combi boiler that recently had a part fixed as the hot water wasn’t getting to the radiators (the hot water in the taps was fine). Since then I now only get hot water to the taps if I switch the hot water to the radiators on as well. Any idea why? Will this be due to a mistake the plumber made when he fitted the last part?

I read recently that it was more the agitation and soap which got rid of the bacteria; even washing in hot water (boiling) didn’t kill all the baddies. These are modern cloth, so they’re made from PUL, bamboo, and microfleece. I hang them in the sun to dry when it’s sunny, but in rainy weather, they dry undercover (still outside).